เครื่องชาร์จ และ ฟื้นฟูแบตเตอรี่ ตะกั่วกรด 12V 8A

แสดงผลด้วยหน้าจอ led 7 segment ทำงานโดยอัตโนมัติทุกขั้นตอน

wisepower charging power to the whole frequency positive and negative pulses, crystal structure, when the negative pulses of different frequencies frequency wave and a vulcanization crystal frequency agreed decomposition occurred same frequency resonance, which in turn reduced to lead sulfate can participate in the electrochemical reaction .While charging it in clear the vulcanization, clean plates to restore the battery capacity!


Model: C1208
Applicable :20-80AH rechargeable lead-acid battery care and maintenance.
Parameters: input AC220V, AC110V; Output: DC ≤ 14.7V ≤ 3A; ≤ 14.7V ≤ 5A DC; DC ≤ 14.7V ≤ 8A
Baby Size: length 180, width 82, 56 mm high.
Gross Weight: about 900 grams.



Instructions for use

1, plug in the power 0.0U, said that the power supply has been through, but the charger and batteries. Uncoupled.
2 micro-current to 0.1A and above battery 0.5V voltage soft start soon joins battery charge, not to hurt the plate.
3, the entire positive and negative pulse frequency charging repair the battery when the battery voltage to rise to 14.7 about substantially filled, and during this interval the charger according to the battery state, and then charging is about 10 minutes to 2.5 hours, in order to eliminate the virtual voltage, Extended battery capacity.
4, the battery is fully charged, the 3 minute "t ES t" diagnosis, if the battery internal micro short circuit since discharge failure or other abnormal, "E5" prompt will be displayed, but does not affect the charging.
5, display the H1.00 - H0.00, 1 hour countdown repair, this feature can be balanced cell voltages.
Display End, the end of all charging fix the battery into power protection status.
, Charger and battery keep for a long time to connect the charger automatically start when the battery voltage drops to about 13V supplementary charge to keep the battery enough electricity state to prevent the loss of electricity sulfide.



Code shows:

Reverse polarity protection: E-

Output short circuit protection: E1

Output fuse fuse protection: E2

Battery charger model does not match the protection: E3

Fan failure protection: E4

Poor battery effectiveness: E5

Program autistic protection: E7

Diagnostic Analysis: tESt

End-of-charge: End





Note:
1 charger should be independently placed or fixed hang on the wall, and must maintain a proper safety distance with vehicles, engines, batteries, flammable charging.
Is prohibited suddenly reverse the process of charging or short circuit.
Non strong vibration and throw touch, non-rain flooding forbidden to disassemble modified. 4. Directly to the vehicle battery is charging, you should turn off the vehicle ignition switch; since then the extension cord should be greater than 2.5 mm2 copper wire, joints should be sealed tin solder and then wrapped with insulating tape.